Goss Community SSC Four High

Circa 1990’s Goss SSC Tower in superb condition. Cleaned, Painted and Repaired. High
speed mechanical test run completed to check for problems, heat or noise.

Goss Community SSC Press Equipment – 22″ Cut-Off

Goss SSC Mono units. Goss SSC folder #9022. Motor and controller, water system and plate bender.

Glunz and Jensen K&F Auto Bender/Punch

This is a “Precision Edge” Glunz and Jensen K&F Auto Bender. Circa 2007.

Prime UV Systems

Two complete and operating Prime UV systems that just came off Goss SSC Press. Each with two 600W lamps, 3 power levels, cabinet, controls, exhaust, complete systems.

DGM 1050 Folder – 22 inch Cut-Off

DGM 1050 Folder New 2000 and in excellent condition. Built in Pennsylvania, USA

Silver Quad Stack

Quad-Stack, installed less than 10 years, acquired from original owner, never ran over 18,000 cph. Serial number B44-194 in excellent condition.

Jardis Infeeds

Jardis Infeeds
In Stock Now!

Low Priced Quad-Stacks

Five Quad-Stacks available immediately. Equipment currently located in Birr, Ireland. Owner needs to get out of building. If you are looking to expand your operation this is an excellent opportunity to acquire late model Quad-Stacks at wholesale prices!

Muller Inserting Machine

Muller 3 into 1 model 227 inserting machine with drive upgrade.

Late Model DGM 430 Towers

DGM 430 Tower – 22-3/4” (578) Cut-off –
One owner, bought new in 2004. Very light use in Aspen Colorado running on average 10,000 copies per day.